Concrete cutting in Mesa AZ - clean, straight lines with the cleanup planned ahead
Need an opening, a trench line or a damaged section cut out of your slab? We cut it clean and plan the cleanup first.
- Licensed and fully insured.
- Free on-site estimates.
- Replies within 1 business day.
What does concrete cutting in Mesa involve?
Concrete cutting is sawing a straight line through a slab or a wall so an opening, a trench line or a damaged section can come out cleanly instead of being broken off ragged. Cornerstone Mesa Concrete is based in Mesa, AZ, and we cut driveways, patios, floors and walls here and across the cities around it.
Most calls start with concrete that's already there and in the way. It might be a cracked section that has to come out, a trench line for a new pipe, or an old edge that a new concrete driveway or patio has to meet. What moves the price most is whether you need only the cuts or the pieces hauled away too, whether the work is indoors, and whether we're sawing a wall or a slab and how thick it is and how much steel rebar runs through it. The schedule usually turns on what comes after the saw, because a cut that leads to digging waits until the underground lines are marked. Your written estimate shows what the price covers, including any removal.
How do you know you need concrete cut?
One panel cracked or sunk
You see one square of the driveway or patio cracked, sunk or lifted while the rest sits fine, which usually means the ground under that piece gave way. A clean cut lets that section come out on its own, and waiting usually lets the broken edges chip and spread into the panels next to it.
A pipe needs to go under
A new drain, water line or conduit has to run where a slab or floor already sits, which means cutting a trench line through the concrete. If it gets broken out with a hammer instead of sawed, the crack can run past where you wanted it, and you end up replacing more than you planned.
Old concrete meets new
You're widening a driveway or adding onto a patio, and the new pour has to butt against a ragged or crumbling edge. A straight saw cut gives the new concrete a clean, solid face to meet, while pouring against a broken edge usually leaves a seam that cracks and chips.
How we handle concrete cutting
First I find out whether you need just the cuts or the pieces broken up and hauled away too, and I write the quote to match, so the price fits the job you actually want done. The surface picks the saw. A flat saw rolls along floors, driveways and sidewalks, and on walls or openings, where a floor saw can't work, we mount a diamond saw on a track. Indoors, we plan for the water, the slurry, which is the gray mud the saw's water makes from concrete dust, and the dust itself before the saw starts. Then we cut the lines and clean up after ourselves.
Cutting is often the first step of something bigger. Once a damaged section is out, our concrete driveway building crew can pour the new piece against a clean edge, and a cut along the back of the house is often where concrete patio construction begins.
Cuts only
This suits you if a plumber, another contractor or your own crew is taking the pieces out after us. We saw the lines and leave the cut panels in place, so you're paying only for the cutting.
Cut, break up and haul
This suits most homeowners who just want the concrete gone and the area ready for what comes next. The quote covers the sawing, breaking the panels into pieces and hauling them away.
Get a written quote for your concrete cut
We reply within one business day to set a time, and I come out to write a free estimate on site, with no obligation. Tell us the surface, the rough length, and whether it's indoors or needs hauling.
Call (480) 645-9450What happens after you call us about a cut in Mesa?
Here's how a cutting job runs from your first call to the final walk-through, and who you'll deal with at each step.
Call and set a visit
When you call or send the form, I set up a time to come out, look at the concrete and hear what you need cut. Let us know then if the work is indoors or if digging follows, because both change the plan.
Get your written estimate
I measure the cuts, look at the surface and how a saw gets to it, and write out what the price covers: the cutting, any breaking up and hauling, and the indoor setup if there is one. You can hold it up against another quote and see exactly what's in each.
We cut, clean up, walk through
Once you're ready, we schedule around the weather, and around the utility marking if digging follows, and our crew cuts while I check in on site. We clean up the slurry and dust, haul the pieces if your quote includes it, and walk the finished job with you.
Why Mesa homeowners call Cornerstone Mesa Concrete for a cut
On a cut, the work that matters most happens before the saw starts, knowing what's under the slab and where the water and slurry will go. Call (480) 645-9450 or send us a note through the contact page, and I'll come take a look.
I price your job myself
I come out to look at the concrete and write the estimate, and our crew runs the saw while I check in on site. You're dealing with the person who priced the job the whole way through.
In business since 2021
I started this business in 2021 after years on the crews of an old-school boss who checked every edge and made us tear out anything that wasn't right. I hold our cuts to that same standard, because a crooked line in concrete is there for good.
A licensed crew when it counts
We're licensed and fully insured. Arizona law lets unlicensed workers take on only work of a casual or minor nature, and not work that needs a local building permit, which matters when a cut is the first step of a bigger job.
Concrete cutting, digging and utility lines in Mesa
When a cut opens the slab so a trench can go in, the job turns into digging, and Arizona law counts trenching, digging, drilling and boring as excavating. The Arizona Corporation Commission says you or a contractor may start only after all the underground utilities are marked, with fines up to $5,000 per violation, so we don't dig under a cut until the marks are down. Whether your project also needs a permit is something we go over with you at the estimate, and when one is needed, we settle with you up front who pulls it and work to the inspections the city or county sets.
Around Mesa we cut a lot of driveways and patios that tie into older concrete, and floors in houses getting new plumbing run under the slab. In the dry heat here, slurry and dust set fast on a driveway, so we clean them up while they're still wet. It's the same kind of work we do on jobs in Gilbert and Tempe.
Questions about concrete cutting in Mesa
How much does concrete cutting cost in Mesa?
Professional saw cutting of an accessible slab usually costs about $4 to $10 per linear foot across the US. That's the market rate for the cuts alone on an easy-to-reach slab, not for breaking up or hauling the pieces. Your written estimate gives the figure for your own job.
Does the price of concrete cutting include hauling the concrete away?
Not always, because sawing concrete and taking it away are separate jobs. Breaking up, hauling and disposal can add more than the sawing itself, so compare quotes on whether they cover just the cuts or the pieces too. Ours spells out which one it covers.
Do I need to contact Arizona 811 before digging a trench under my slab?
Yes, once the work goes below the slab into the dirt, because the underground lines have to be marked before any digging starts. Arizona 811 says to create a ticket at least two full working days before you dig, not counting weekends and state holidays. We work out with you at the estimate who places it, so the marks are down before trench day.
How messy is indoor concrete cutting?
It's wet and dusty unless it's planned, which is why indoor work usually costs more than outdoor cutting. Water control, slurry recovery, ventilation, barriers or dust extraction are part of the job, not extras. Ask any crew how the slurry will be contained and cleaned up, since letting it run into a storm drain is an environmental violation in many areas.
How do I get my floor ready for indoor concrete cutting?
Clear the whole area you want cut. When a crew checks the concrete before cutting, the device slides right on the surface across the working area, and clutter, thick carpet or a loose finish leaves blind spots. We'll tell you at the estimate what needs to move.
What causes a small concrete cutting job to cost more than expected?
Usually it's the minimum or trip charge, because on a short cut it can make up most of the price, more than the per-foot rate. If you have a few cuts in mind, it helps to have them all looked at on the same visit.
Services that often follow a concrete cut
- Concrete driveway building
If the cut is taking out a broken section or making room to widen your driveway, we can pour new concrete that meets the old edge cleanly.
- Concrete patio construction
When you want outdoor living space off the back of the house, a new patio slab can start right where an old one was cut back.
Cities we take concrete cutting jobs in
Cornerstone Mesa Concrete is based in Mesa, Arizona, and takes jobs across the cities around it. The 12 cities listed here, from Chandler to Scottsdale, each have their own page, and they aren't the only places we work.
Mesa, AZ
Tell us what needs cutting and where
Call (480) 645-9450 or use the form before the rest of your project is booked, so the cut, the hauling and anything poured after it line up.